Table of Contents
How do you force a Kenmore washer to drain?
Squeeze the locking pin on the end of the drain hose that is connected to the back of the washer if you will be draining the water into a floor drain. Pull the hose away from the washer to disconnect it. The water will pour out as soon as the hose is disconnected.
Why is my Kenmore Elite washer not draining or spinning?
Most Frequent Causes for Washer won’t drain Sometimes, socks and other small articles of clothing can get into the drain system and clog the pump hose or the pump itself. Remove the hoses from the pump and check for any obstructions. The lid switch assembly prevents the washer from spinning when the lid is open.
Why is my washer not spinning and draining?
If your washer won’t drain or spin, the water level control may be faulty. Open the machine’s control panel and look for a plastic tube attached to the water level valve. If it’s clogged, clear it out with vinegar. If the valve itself is corroded, it may need to be replaced.
Is there a reset button on a Kenmore washer?
To reset your Kenmore washer and, since Kenmore washers do not have a reset button, go ahead and turn the washer off. Disconnect the washer from its power source. Then, wait for about three to five minutes.
Where is the drain pump on a Kenmore washer?
The drain pump is located in the lower front corner of most Kenmore front-loading machines, and the most difficult part of the job may be getting to it. If the machine doesn’t have an access panel, as some do, you’ll have to take the entire front panel off.
Why is my washer not draining all the way?
Your washer may have a clogged drain hose or the pump may be broken. A broken lid switch or belt could also be the culprit. It may even be something as simple as the hose being jammed. Whatever the reason, the water will need to be drained from the washing machine before any work or diagnosis can be done.