What is the best grade of lumber?
Hardwood grades are: FAS (First and Second) is the highest grade of hardwood lumber. It’s usually 6-inches x 8-inches and is 83 percent defect-free on its best side. Select is 4-inches x 6-inches and 83 percent defect free on its best side.
What is better #1 or #2 lumber?
Typically wood that is two or more inches thick is graded only for strength, denoted by #1, #2 and so on. And because stronger lumber has fewer and smaller knots, it’s typically more attractive. So the general rule of thumb for lumber grades is this: the lower the number, the more strength and better appearance.
What is #3 grade lumber?
#3 Grade: When appearance is of no concern, this construction grade will contain large knots, excessive wane, occasional knot holes, and manufacturing defects.
What does FAS mean in lumber?
First and Seconds
FAS. FAS derives from an earlier grade known as “First and Seconds”. It is the best and most expensive grade. Boards 6″ and wider, 8′ and longer. Yields 83-1/3 percent of clear face cuttings with minimum sizes of 4″ x 5′, or 3″ x 7′.
What is Grade C wood?
C Grade is made up of reclaimed waste wood from discarded furniture and other wooden fixtures and fittings. It can include MDF and chipboard material as well as wood. This material is often contaminated with varnishes, glues and other coatings.
What is the best available grade of hardwood lumber?
FAS
The highest grade boards are FAS and Select, followed by #1 Common and #2 Common. What grade you choose depends on your project. Some projects, such as tabletops and high quality furniture, may dictate the highest grade available.
What is premium pine?
Premium grade is similar to the finish grade but encompasses boards with larger knots. Standard grade is used mainly for construction where a less finished board is acceptable. Industrial grade is the lowest grade.
What is #2 grade pine?
Grade Characteristics and Typical Uses Recommended for construction where high strength, stiffness and good appearance are desired. *No.2 Dense. No.2. *No.2 Non-Dense. Recommended for most general construction uses where moderately high design values are required.
What is #2 Douglas fir?
Douglas Fir has the highest ratings of any western softwood for fiber stress in bending, tension to parallel to grain, horizontal shear, compression perpendicular and compression parallel to grain.
What does BTR mean on lumber?
Better
Grades:
BTR | Better |
---|---|
B&B | B & Better |
CON COM | Construction Common Redwood |
CON HEART | Construction Heart Redwood |
STD BTR | Standard & Better |