What is EPDM tape primer?
A solvent-based product designed for one-step cleaning and priming of EPDM surfaces to be bonded with In-Seam Tapes, Uncured Flashing Tapes, Cured Cover Tapes and Pre-Taped membranes.
What is TPO primer?
A solvent-based product designed for one-step cleaning and priming of TPO surfaces to be bonded with In-Seam Tapes, Uncured Flashing Tapes, Cured Cover Tapes, and Pre-Taped membranes.
What is EPDM cover tape used for?
APPLICATIONS: LionGUARD Cover Tapes are for typical roofing applications such as cover for most metal terminations including gravel – stops and drip edge, and extensively used for horizontal patching, seam repairs and seam overlays. Cover Strip product is a peel and stick cured cover tape.
What is splice adhesive used for?
Seal Trust™ Splice Adhesive is a black adhesive designed for use as a seam adhesive during the installation of EPDM membrane systems where seaming together two sheets are required. It may also be used as a contact adhesive to bond membranes to suitable substrates as a bonding adhesive substitute.
What can I use for EPDM primer?
What are the Adhesives and Primers used in EPDM Roofing?
- Quickbond Water Based Bonding Adhesive – Rubber Flat Roof.
- Quickbond 1500 Contact Adhesive – Rubber Flat Roof.
- Rubberall Seam Tape Primer – Rubber Flat Roof.
- SX Siroflex MS Polymer – Rubber Flat Roof.
- Lap Caulk – Rubber Flat Roof.
What is primer used for on rubber roof?
RoofKit rubber roofing seam primer is a solvent-based primer used for cleaning RoofKit rubber roofing membrane before applying seam tape, cover tape, or any flashing product. This product is applied with a scrub pad. Do not apply primer directly to tape products.
What is TPO primer made of?
DESCRIPTION Metacrylics™ TPO Primer is an all-acrylic polymer designed for use in pigmented elastomeric roof coating basecoats to provide adhesion to weathered Thermoplastic PolyOlefin (TPO) roofing membranes.
What is seam tape?
Seam tape is a layer of tape made of polyurethane film that is placed by the manufacturer under the seams to block water from entering the seams. Seam tape has a more difficult time adhering to thinner fabric tents, and can breakdown or flake off over time, particularly with exposure to moisture, heat and humidity.
Can you overlap EPDM?
Overlap the two rubber membranes by 75mm (3inches) Overlap the two rubber membrane sheets to be joined by 75mm (3inches). It is common on long runs to overlap the two sheets by more than 3″ and then cut back the top sheet of rubber membrane once the splice tape has been stuck to the bottom sheet.