How do I reset my power pole remote?
loosen the 4 screws that hold the cap to the remote box and hold the program button on the right side, (its red) for 3 seconds and then hold down a button on your remote. The remote will re-learn the signal and you should be good to go, if everything else is working normally. Featuring.
How do I reconnect my power pole remote?
57 second clip suggested3:37Pairing Power Pole Remotes – YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd locks up and push that one. So that’s there then you take the UP. Button push and hold here.MoreAnd locks up and push that one. So that’s there then you take the UP. Button push and hold here. Until that light locks up green hit the UP button here. That’s paired and then you take the opposite.
How do you reset a micro power pole?
51 second clip suggested1:00Calibrating the Power-Pole MICRO Anchor – YouTubeYouTubeStart of suggested clipEnd of suggested clipIt into the micro unit. And on the top of the unit there’s an anchor force button and a batteryMoreIt into the micro unit. And on the top of the unit there’s an anchor force button and a battery level but press them both at the same time.
How do you program a power pole controller?
57 second clip suggested2:34JLM University: Pairing CM2 remotes to the Power-Pole HPU – YouTubeYouTubeStart of suggested clipEnd of suggested clipNext press either the up or down button on the controller. You are pairing for one second whenMoreNext press either the up or down button on the controller. You are pairing for one second when paired the hpu will beep and the led will turn off and then begin to flash steadily.
How do you use the C Monster app?
57 second clip suggested1:40Power-Pole C-Monster App – YouTubeYouTube
How do you prime a power pole pump?
STEP 1 Connect power to the HPU. STEP 2 Manually place the Power-Pole Anchor in the deployed position. STEP 3 Using the Wireless Dash Switch set to SLOW speed, hold the DOWN button until the RED LED on the dash switch stops flashing and the pump stops running. (Approximately 20 sec.)
How do I change the battery in my power pole remote?
IMPORTANT: Make sure battery replacement is done in a dry location. STEP 1: Remove Key Fob Cover using a Flat-Tip screwdriver. FIG 1 STEP 2: Remove Switch Membrane and Circuit Board from the base FIG 2 STEP 3: Remove battery from holder and replace with a CR2032 3v Lithium Coin Battery. STEP 4: Reassemble Key Fob.
How do you reset a power pole charge?
Hold down the orange button on the CHARGE for approx 15 seconds. This will reset the charger.
How do you pair a micro power pole?
Press and hold the “PRGM/PAIR” button on top of the MICRO Driver Unit, press and hold for 3 seconds, until the LED turns solid green. 2. Press and hold either the UP or DOWN button on the wireless controller you are pairing until the unit responds.
How do you update power poles?
55 second clip suggested2:30Power-Pole Firmware Update with the C-Monster App – YouTubeYouTube
What is Power-Pole C-Monster?
C-MONSTER CONTROL SYSTEM PUTS YOU IN CHARGE C-Monster allows for the seamless integration of all Power-Pole products by using the most advanced wireless network in the marine industry.
How do you bleed air from a Power-Pole?
Cycling the power pole up and down will bleed it. “Using the control raise and lower the Power-Pole several times to prime the system.